Ciencia e Ingeniería en Alimentos y Biotecnología
Permanent URI for this communityhttp://repositorio.uta.edu.ec/handle/123456789/412
Browse
8 results
Search Results
Item Modelado de la cinética de secado e isoterma de adsorción de agua de mesocarpio de zapallo (Cucurbita máxima Duchesne) sometido a diferentes tratamientos previos al secado(Universidad Técnica de Ambato. Facultad de Ciencia e Ingeniería en Alimentos y Biotecnología. Carrera de Alimentos, 2025-02) Toaquiza Landeta, Arlett Estefanía; Acurio Arcos, Liliana PatriciaThis work studied the behavior of pumpkin being subjected to boiling, steam and microwave as pretreatments, with a subsequent drying process at 65 degrees Celsius for 8 hours. The samples reached a final humidity of 2.1 percent for the control, 1.8 percent for the sample pretreated with boiling water, 3.2 percent for steam and 2.6 percent for microwaves. The drying kinetics were adjusted to different mathematical models (Newton, Page, modified Page, Henderson & Pabis, Logarithmic, and Wang & Singh), being the Page model the one that presented a better fit. Adsorption isotherms were created by applying supersaturated salts that allowed simulating environments with relative humidities between 11.78 percent and 80.12 percent. The equilibrium humidity values reached by the samples were adjusted to the BET and GAB models. It was observed that the GAB model presented a better fit for the control, subjected to boiling water and microwaves. In contrast, the BET mathematical model allowed explaining the behavior of the pumpkin sample pretreated with steam. The sample pretreated with microwaves presented a higher water adsorption capacity in the monolayer with a value of 0.0558 grams of water per gram of dry solid. Finally, the samples exceeded a relative humidity of 30 percent, they showed a substantial increase in the flours' water adsorption capacity, so storage conditions that should not exceed 60percent relative humidity.Item Modelado de la cinética de secado del mesocarpio y de las isotermas de adsorción de la harina de la calabaza (Cucurbita pepo L.) sometida a diferentes pretratamientos(Universidad Técnica de Ambato. Facultad de Ciencia e Ingeniería en Alimentos y Biotecnología. Carrera de Alimentos, 2025-02) Tibanlombo Timbila, Daniela Salomé; Acurio Arcos, Liliana PatriciaCucurbits are fruits rich in bioactive compounds; however, their consumption is mainly limited to fresh forms. This study analyzed the drying kinetics of winter squash (Cucurbita pepo L.) mesocarp subjected to precooking with boiling water, steam, and microwaves, and the analysis of the adsorption isotherms of the flour obtained from the different pretreatments. A decrease of more than 80 percent of the initial moisture of the samples was observed. The determination of the drying rate showed that the combination of microwave and convective drying at 65 Celsius degrees for eight hours was the ideal treatment to obtain a critical moisture of 2.68 kg water per kg dry solids and an equilibrium moisture of 0.04 kg water per kg dry solids. The water loss rate was adjusted to six main mathematical models, with the Modified Page model providing the best fit. When determining the effective diffusivity coefficient of water, it was found that the pretreatments reduce the activation energy. Therefore, it is concluded that these previous stages accelerate the drying process. The shelf life of the flours was examined through the construction of sorption isotherms. These presented type II sigmoid curves due to their macroscopic surface structure and hydrophobic nature. Regarding the fit performed with the BET and GAB models, it was confirmed that the adhesion of water molecules is stronger in the monolayer. The correlation coefficient allowed the establishment of the BET model as the best approximation.Item Modelado de la cinética de secado e isoterma de adsorción de la lenteja de agua (Lemna minor)(Universidad Técnica de Ambato. Facultad de Ciencia e Ingeniería en Alimentos y Biotecnología. Carrera de Alimentos, 2024-08) Castillo Salazar, Marco Sebastian; García Pazmiño, María EugeniaThe need to obtain new sources of food over time has been fundamental for the development and sustainability of humanity. Currently, the trend towards the consumption of functional and nutritious foods has opened a line of research in the food industry. In this context, we are interested in duckweed (Lemna minor), which has nutritional properties, particularly its high protein content, making it a source of interest in recent years. The research focuses on obtaining the drying kinetics curve and subsequently fitting the data to mathematical models and constructing the adsorption isotherm using the GAB and BET models. Fresh duckweed (Lemna minor) was subjected to a drying process at 60 degrees Celsius for 6 consecutive hours, with weight measurements taken at established times. Additionally, the adsorption isotherm was constructed by placing 8 capsules with duckweed flour (Lemna minor) in 5 jars with 5 supersaturated salts to evaluate moisture adsorption. The results obtained determined that the Page model best describes the drying process, and the BET model best fits the adsorption isotherm. These results serve as a basis for future research on this potential aquatic plant and its development in the food industry.Item Determinación de las isotermas y cinéticas de adsorción de metales pesados (Zn, Cr, Pb, Ni, Cu) sobre adsorbentes de zeolita y piroclasto volcánico para el tratamiento de aguas residuales de lavadoras automotrices del cantón Ambato(Universidad Técnica de Ambato. Facultad de Ciencia e Ingeniería en Alimentos y Biotecnología. Carrera de Ingeniería Bioquímica, 2023-09) Arguello Rodríguez, Diter David; Peñafiel Ayala, Rodny DavidWastewater from human activity and industry mostly ends up in water effluents without any prior treatment, which exacerbates the level of contamination of this resource, these practices cause the decrease in water availability. Automotive washing machines generate high loads of hydrocarbons and heavy metals of which vehicles are composed, which is why the objective of the project was the determination of isotherms and kinetics of adsorbent materials on the wastewater of automotive washing machines in the Ambato canton. The present experimental research project consists of an analysis of adsorption isotherms on heavy metals with known initial concentrations of heavy metals, applying linear adjustment and models of Langmuir and Freundlich isotherms, for which the adsorption capacity of a porous material (pyroclast) and materials with a high degree of ion exchange (mordenite zeolite and cliptonilolite) was evaluated. In addition, the adsorption efficiency of the materials was verified on a sample of synthetic water (distilled water and metal) and one of matrix water (wastewater and metal cations), thus executing a simple adsorption process and a competitive adsorption system, for the preparation of samples the regulations of the Unified Text of Secondary Environmental Legislation (TULSMA) were taken as reference. Finally, it was shown that adsorbent materials can decrease the concentration of heavy metals in wastewater, removing up to 95 percent of the initial load of contaminants.Item Modelado de la cinética de secado e isotermas de adsorción de agua de oca amarilla (Oxalis tuberosa variedad amarilla) y oca roja (Oxalis tuberosa variedad roja)(Universidad Técnica de Ambato. Facultad de Ciencia e Ingeniería en Alimentos y Biotecnología. Carrera de Alimentos, 2023-03) Baquerizo Bacilio, Ariel Joseph; Acurio Arcos, Liliana PatriciaThe Yellow Oca and Red Oca are tubers that contain a large amount of water, which makes them perishable food. Drying is a process where the amount of water in the food is reduced through mass and heat exchange between the matrix and hot air. In this study, these tubers were dried at 65 degrees Celsius for 8 hours. The analysis of the drying kinetics allowed it to determine the critical humidity, which yielded values of 0.059 kg water on kg dry solid and 0.086 kg water on kg dry solid for yellow and red Oca, respectively. In addition, seven mathematical models commonly used for analyzing drying kinetics in foods were used (Newton, Page, modified Page, Henderson, and Pabis, Logarithmic, Thomson, and Fick), and it was observed that the model that best fits is Newton's. On the other hand, adsorption isotherms were built using salts found in a water activity range of 0.11 to 0.8. It was determined that the yellow and red Oca meals generate type II isotherms. The data from these isotherms were adjusted to the mathematical models of BET and GAB. It was determined that the model that best fits the data is GAB due to the range in which it works.Item Modelado de la cinética de secado e isoterma de adsorción de agua de oca blanca (Oxalis tuberosa variedad Blanca) y zanahoria blanca (Arracacia xanthorrhiza Bancr.)(Universidad Técnica de Ambato. Facultad de Ciencia e Ingeniería en Alimentos y Biotecnología. Carrera de Alimentos, 2023-03) Borja Suárez, Daniela Alexandra; Acurio Arcos, Liliana PatriciaThe present work focused on studying the drying kinetics of Oca blanca and Zanahoria blanca in a drying process carried out at a temperature of 65 Celcius degrees for 8 hours. The determination of the critical humidity yielded the values of 0.06 kg wáter per-kg dry solid and 0.07 kg wáter per-kg dry solid for Oca blanca and Zanahoria blanca, respectively. In addition, the kinetics data were fitted to the mathematical models of Newton, Page, modified Page, Henderson and Pabis, Logarithmic, Thomson, and Fick. Through the determination coefficient (R2), the estimated mean error (SE), and the relative mean deviation percentage (P), it was determined that the Page model presented a better fit. On the other hand, the adsorption isotherms were built using supersaturated salts, allowing them to maintain environments with a relative humidity of 11 to 80 percent. The isotherms showed a type II sigmoidal shape, and the values were fitted to the GAB and BET mathematical models. Through the coefficient of determination (R2), a better fit with the GAB model was determined. The monolayer moisture content for the two matrices yielded values of 0.055 kg wáter per-kg dry solid and 0.057 kg wáter per-kg dry solid for Oca blanca and Zanahoria blanca, respectively. This constant is related to the humidity limit that the sample must have to remain stable during storage.Item Modelado de la cinética de secado convectivo e isotermas de adsorción de agua de camote morado (Ipomoea batatas) y mashua (Tropaeolum tuberosum), provenientes de la provincia de Tungurahua(Universidad Técnica de Ambato. Facultad de Ciencia e Ingeniería en Alimentos y Biotecnología. Carrera de Alimentos, 2023-03) Vayas Velastegui, Marcelo Fabian; Acurio Arcos, Liliana PatriciaThe present work correlated data on the drying kinetics of purple sweet potato (Ipomoea batatas (L.) Lam.) and mashua (Tropaeolum tuberosum Ruiz & Pav) with referential mathematical models. Different mathematical models were used to predict the drying kinetics of these tubers. The Page model was the one that best fitted the experimental data of purple sweet potato, with a coefficient of determination of 0.992. While the mashua was adapted to the Thomson model with coefficient of determination of 0.998. On the other hand, adsorption isotherms were built using hygroscopic salts with aw between 0.1178 and 0.8012. The adsorption isotherms were of type II and allowed to predict the w0, optimal humidity at which its stability and conservation would be ensured. The curves were evaluated using the GAB and BET mathematical models. In mashua flour, the BET model was the one that best describes its adsorption isotherm with a coefficient of determination of 0.997. In contrast, purple sweet potato was better adapted to the GAB model with a coefficient of determination of 0.992.Item Caracterización de agua residual proveniente de la industria automotriz del cantón Ambato y su tratamiento por adsorción para remoción de metales(Universidad Técnica de Ambato. Facultad de Ciencia e Ingeniería en Alimentos y Biotecnología. Carrera de Ingeniería Bioquímica, 2022-03) Aguas Salazar, Bryan Gilmar; Peñafiel Ayala, Rodny DavidMost of the residual effluents are discharged into bodies of water without any type of pre-treatment, which increases the risk of contamination of surface and groundwater. This experimental project consists of a physicochemical characterization and a pre- treatment of the residual effluent generated in several car laundries of the Ambato canton to suggest alternative treatments for the removal of metals present in the effluent, in order to be disposed of properly. For this, random samples were collected from the laundries at different points for subsequent homogenization, these samples were characterized through 14 physicochemical parameters. These results were compared with the current Texto Unificado de Legislación Secundaria de Medio Ambiente (TULSMA), where it was observed that they do not comply with some parameters established by the standard. On the other hand, for its pre-treatment with adsorption isotherms, solutions with known concentrations of Cr, Ni, Cu and Zn were used, which were added in different types of adsorbent materials (peat, limestone and activated carbon) to different weights, obtaining a result of 24 samples for each metal that were subsequently analyzed by spectrophotometry. Thanks to this, it was possible to describe the individual behavior of each pollutant used in the Langmuir and Freundlich models, finding a great correlation in the latter according to the determined parameters. Once the results were analyzed, it was established that the degree of removal of each contaminating metal was greater than 90 percent; having active carbon and peat as the best bioadsorbent.