Estudio comparativo del proceso de soldadura SMAW y GTAW en un acero inoxidable martensítico AISI 420 y su influencia en las propiedades mecánicas
No Thumbnail Available
Date
2020
Journal Title
Journal ISSN
Volume Title
Publisher
Universidad Técnica de Ambato. Facultad de Ingeniería Civil y Mecánica, Carrera de Ingeniería Mecánica
Abstract
The research work refers to the comparison of the SMAW and GTAW welding
processes in a martensitic stainless steel, with different contribution materials in each
of the welding processes, to achieve technological and scientific benefits in the
industries, obtaining mechanical properties equal or better than existing ones with a
lower manufacturing cost.
This project was carried out in an AISI 420 martensitic stainless steel with the SMAW
and GTAW welding processes with input material in the GTAW ER312, ER308
process and a combination of ER308 and ER312; while in the SMAW process E312-
16, E308 L-16 and a combination of both were used, continuing with the construction
of the specimens to subsequently perform tensile, impact and hardness tests
VICKERS, resulting in valid results with The purpose of evaluating its influence on
the mechanical properties of the joints produced, based on the AWS code B4.0, the
tests being carried out at the Carrocero Metalmechanical Productive Development
Center of the Municipal Government of Tungurahua.
After having performed the required tests, an analysis and interpretation of the results
was carried out, obtaining that the GTAW welding process is the most recommended,
while the contribution material that has the highest tensile strength 674.6 MPa, as well
as limit of creep 136,380 Mpa, is the ER - 312.
Finally, conclusions and recommendations of the results obtained were given.
Description
El trabajo de investigación hace referencia a la comparación de los procesos de
soldadura SMAW y GTAW en un acero inoxidable martensítico, con distintos
materiales de aporte en cada uno de los procesos de soldadura, para lograr beneficios
tecnológicos y científicos en las industrias, obteniendo propiedades mecánicas iguales
o mejores que las existentes con un menor costo de fabricación.
Este proyecto se realizó en un acero inoxidable martensítico AISI 420 con los procesos
de soldadura SMAW y GTAW con material de aporte en el proceso GTAW ER 312,
ER 308 y una combinación de ER 308 y ER 312; mientras que en el proceso SMAW
se usó E 312-16, E 308 L-16 y de igual manera una combinación de ambas,
continuando con la construcción de las probetas para posteriormente realizar ensayos
de tracción, de impacto y de dureza VICKERS, originando resultados válidos con la
finalidad de evaluar su influencia en las propiedades mecánicas de las juntas
elaboradas, fundamentándose en el código AWS B4.0, realizándose los ensayos en el
Centro de Fomento Productivo Metalmecánico Carrocero del Gobierno Municipal de
Tungurahua.
Posteriormente de haber realizado los ensayos requeridos, se procedió a efectuar un
análisis e interpretación de resultados, obteniendo que el proceso de soldadura GTAW
es el más recomendable, mientras que el material de aporte que tiene mayor resistencia
a la tracción 674.6 MPa, así como límite de fluencia 136.380 Mpa, es el ER – 312.
Finalmente se dieron conclusiones y recomendaciones de los resultados obtenidos.
Keywords
SOLDADURA SMAW, SOLDADURA GTAW, ACERO INOXIDABLE, AISI 420, PROPIEDADES MECÁNICAS