Influencia de la exposición a la intemperie en la resistencia a la tracción, flexión e impacto de dos materiales compuestos de matriz poliéster reforzados con fibra de abacá y plátano
No Thumbnail Available
Date
2020-09
Authors
Journal Title
Journal ISSN
Volume Title
Publisher
Universidad Técnica de Ambato. Facultad de Ingeniería Civil y Mecánica, Carrera de Ingeniería Mecánica
Abstract
The present experimental work has the determination of analysis the influence of outdoor
exposure under ASTM D1435-99 (maximum and minimum temperature, relative
humidity, average rainfall and UV radiation), time (zero to six months) angle of exposure
(45 degrees) and type of fiber (abaca and banana), in the behavior of the mechanical
properties of composite materials.
By means of the elaboration of two composite materials made with a polyester matrix and
abaca fiber and another of a polyester matrix and banana fiber, the probes with the
following dimensions (length, width and thickness) are made for the tensile test 250x25
x4 mm under ASTM D3039-2017, bending specimens 160x13x4 mm under ASTM
D7264 and 80x10x4 mm charpy impact specimens under NTE INEN-ISO 179-2 .
The first test was carried out at the beginning of the study and the second after six months,
the data of the climatological variations and the variations of the weights of the specimens
were also recorded. With the help of the data obtained, it was possible to verify that there
are variations in the mechanical properties of both materials in the tensile, flexural and
impact tests.
The results of the study are presented through a statistical and graphic analysis carried out
in the experimental work.
Description
El Presente trabajo experimental tiene la finalidad de analizar la influencia de la
exposición a la intemperie bajo la norma ASTM D1435-99 (temperatura máxima y
mínima, humedad relativa, lluvia promedio y radiación UV), tiempo (cero a seis meses)
ángulo de exposición (45 grados) y tipo de fibra (abacá y plátano), en el comportamiento
de las propiedades mecánicas de los materiales compuestos.
Por medio de la elaboración de dos materiales compuestos realizados uno con matriz
poliéster y fibra de abacá y otro de matriz poliéster y fibra de plátano, se efectuó las
probetas con las siguientes dimensiones (largo, ancho y espesor), para el ensayo de
tracción 250x25x4 mm bajo la norma ASTM D3039-2017, las probetas de flexión
160x13x4 mm bajo la norma ASTM D7264 y las probetas de impacto charpy 80x10x4
mm bajo la norma NTE INEN-ISO 179-2.
Se efectuó el primer ensayo al inicio del estudio y el segundo después de seis meses,
también se registraron los datos de las variaciones climatológicas y las variaciones de los
pesos de las probetas. Con la ayuda de los datos obtenidos se pudo verificar que existen
variaciones en las propiedades mecánicas en ambos materiales en los ensayos de tracción,
flexión e impacto.
Los resultados del estudio se presentan mediante un análisis estadístico y gráfico
efectuado en el trabajo experimental.
Keywords
MATRIZ POLIÉSTER REFORZADO, MATERIALES COMPUESTOS, FIBRA DE ABACÁ, FIBRA DE PLÁTANO, RESISTENCIA A LA TRACCIÓN, ENSAYO DE TRACCIÓN, ENSAYO DE FLEXIÓN, PROCESO DE ESTRATIFICACIÓN MANUAL, RESINA POLIÉSTER, ENSAYO DE IMPACTO CHARPY