Fabricación del mecanismo de conformado de la punta de un tubo hipodérmico usado en un dispositivo mecánico generador de flujo con presión positiva CPAP usado como alternativa en el tratamiento de pacientes con covid-19
No Thumbnail Available
Date
2021-09
Journal Title
Journal ISSN
Volume Title
Publisher
Universidad Técnica de Ambato. Facultad de Ingeniería Civil y Mecánica, Carrera de Ingeniería Mecánica
Abstract
With the development of the mechanism system for shaping the tip of a hypodermic
tube, it will allow the manufacture and adaptation of this fundamental internal element
of the respirator, consequently it will help to reduce the time of elaboration and
assembly of the same.
The methodology of this technical project begins with an evaluation of the information
provided by the Mercedes AMG company and the UCL. For the design of the
deformation mechanism of hypodermic tubes, SolidWorks software was used, while
ANSYS software was used for simulation, in which an analysis of the machine's
infrastructure was carried out to determine that there is no overstress and that it may
cause failures; likewise, an impact analysis was carried out in a specific contact region,
between the tip and the hypodermic tube, based on a height of fall of an element
(weight), in order to determine the deformation of the tube. Finally, the construction
of the machine was executed.
Functional tests were carried out in the laboratory of the Faculty of Civil and
Mechanical Engineering, where results of 1.31 mm (average value) of deformation of
the hypodermic tube were obtained, tests that were adapted with the simulations
carried out, resulting in a correct operation of the mechanism.
Description
Con el desarrollo del sistema de mecanismo de conformado de la punta de un tubo
hipodérmico permitirá la fabricación y adaptación de este elemento interno
fundamental del respirador, consecuentemente ayudará a la reducción del tiempo de
elaboración y ensamble del mismo.
La metodología del presente proyecto técnico inicia con una evaluación de la
información proporcionada por la empresa Mercedes AMG y la UCL. Para el diseño
del mecanismo de deformación de tubos hipodérmicos se utilizó el software
SolidWorks mientras que para la simulación se utilizó el software ANSYS en el cual
se realizó un análisis de la infraestructura de la máquina para determinar que no exista
un sobreesfuerzo y pueda causar fallos; así mismo se realizó un análisis de impacto en
una región de contacto específica, entre la punta y tubo hipodérmico, en base a una
altura de caída de un elemento (peso), con el fin de determinar la deformación del tubo.
Finalmente, se ejecutó la construcción de la máquina.
Se realizaron pruebas de funcionamiento en el laboratorio de la facultad de Ingeniería
Civil y Mecánica, donde se obtuvieron resultados de 1.31 mm (valor promedio) de
deformación del tubo hipodérmico, pruebas que se adecuaron con las simulaciones
realizadas, dando como resultado un correcto funcionamiento del mecanismo.
Keywords
MECANISMO, CONFORMADO, TUBO HIPODÉRMICO, SIMULACIÓN, DEFORMACIÓN