Mejora del coeficiente de convección en condensadores de instalaciones frigoríficas mediante el subenriamiento del gas de entrada por reinyección de líquido
Date
2018
Journal Title
Journal ISSN
Volume Title
Publisher
Universidad Técnica de Ambato. Facultad de Ingeniería Civil y Mecánica, Carrera de Ingeniería Mecánica
Abstract
The research work focuses on the study of the convection coficient
of the condenser in a refrigeration cycle. The superheating of the
incoming gas to the condenser was reduced by the reinjection of
liquid. An analysis was carried out by means of a mathematical
model and an experimental one with data from the cooling testing
bench of the energy laboratory of the Mechanical Engineering Career.
A mathematical model was used to predict the operation of the refrigeration
system, to determine if there is an improvement in the
convection coeficient of the condenser when liquid is injected at
the inlet of the condenser. These data were compared with the
experimental data. The cooling bench was re-powered and equiped
for data collection, using pressure sensors, temperature and
flow meters located at fundamental points in the cooling circuit.
A database was obtained to analyze and compare the results with
the predictive mathematical model.
Once the results were analyzed, a non-representative reduction in the
convection coeficient in the condenser was obtained.
Description
El trabajo de investigación se centró en el estudio del coficiente de
convección de un condensador de una instalación frigorfica. Se
redujo el sobrecalentamiento del gas de entrada al condensador
mediante la reinyección de líquido, para lo cual se realizó un aná-
lisis con un modelo matemático y uno experimental con toma de
datos de la bancada de refrigeración del laboratorio de energías de
la Carrera de Ingeniería Mecánica.
Se realizó un modelo matemático para predecir el funcionamiento del
sistema frigorfico, y determinar si existe una mejora en el coeficiente de convección del condensador al reinyectar líquido a la
entrada del mismo. Estos datos fueron comparados con los datos
experimentales. La bancada de refrigeración fue repotenciada y
adecuada para la toma de datos, mediante sensores de presión,
temperatura y caudalímetros ubicados en puntos fundamentales
en el circuito de refrigeración. Se obtuvo una base de datos para
analizarlos y comparar los resultados con el modelo matemático
predictivo.
Una vez analizados los resultados, se obtuvo una reducción no representativa
en el coeficiente de convección en el condensador.
Keywords
SUBENRIAMIENTO, INSTALACIONES FRIGORÍFICAS, REINYECCIÓN DE LÍQUIDO, SISTEMAS DE REFRIGERACIÓN, TUBO VENTURI, DIMENSIONAMIENTO DEL MOTOR, ESTUDIO TERMODINÁMICO