Por favor, use este identificador para citar o enlazar este ítem: https://repositorio.uta.edu.ec/jspui/handle/123456789/26801
Título : Diseño por elementos finitos de una roto bomba accionada con una turbina Pelton para riego de cultivos en los sectores vulnerables
Autor : Carrillo Rosero, Carlos Mauricio
Valencia Chávez, Cristian Javier
Palabras clave : ELEMENTOS FINITOS
ROTOBOMBA
TURBINA PELTON
SECTORES VULNERABLES
TURBINA HIDRÁULICAS
ANSYS
CFD
BOMBAS CENTRÍFUGAS
Fecha de publicación : oct-2017
Editorial : Universidad Técnica de Ambato. Facultad de Ingeniería Civil y Mecánica. Carrera de Ingeniería Mecánica
Resumen : The present work of investigation is about the design of a Pelton turbine that works with conditions of net jump of 45 m and flow of 0.05 m3 / s, was realized with the module CFD to determine the conditions of operation like pressure, speed, turbulence. In the design of the turbine consists of the geometry of the spoons, the dimensions of the impeller, injector, injector needle and mechanical dimensioning of the turbine shaft. The CFD analysis was performed taking into account the considerations that the turbine works with biphasic flow, ie there is presence of water and air, was used rotating mesh to rotate the impeller, stationary mesh for injectors and part of the Case. A study was carried out on the convergence of the mesh and its influence on the results, as well as the different models of turbulence available. These results were validated by calculating the efficiency of the turbine and the triangle of velocities at the exit of the turbine spoons, obtaining errors of 12.19% and 8.43%, respectively.
Descripción : El presente trabajo de investigación trata sobre el diseño de una turbina Pelton que trabaja con condiciones de salto neto de 45 m y caudal de 0.05 m3/s, se realizó análisis con el módulo CFD para determinar las condiciones de funcionamiento como presión, velocidad, turbulencia. En el diseño de la turbina consta de la geometría de las cucharas, las dimensiones del rodete, inyector, aguja del inyector y el dimensionamiento mecánico del eje de la turbina. El análisis por CFD se realizó tomando en cuenta las consideraciones de que la turbina trabaja con flujo bifásico, es decir que se tiene presencia de agua y aire, se utilizó malla rotatoria para hacer girar al rodete, malla estacionaria para los inyectores y parte de la carcasa. Se realizó un estudio sobre la convergencia de la malla y su influencia en los resultados, así como también los diferentes modelos de turbulencia que se dispone. Estos resultados fueron validados por medio del cálculo de la eficiencia de la turbina y el triángulo de velocidades a la salida de las cucharas de la turbina obteniéndose errores de 12.19% y 8.43%, respectivamente.
URI : http://repositorio.uta.edu.ec/jspui/handle/123456789/26801
Aparece en las colecciones: Ingeniería Mecánica

Ficheros en este ítem:
Fichero Descripción Tamaño Formato  
Tesis I. M. 418 - Valencia Chávez Cristian Javier.pdfTESIS A TEXTO COMPLETO2,55 MBAdobe PDFVisualizar/Abrir


Los ítems de DSpace están protegidos por copyright, con todos los derechos reservados, a menos que se indique lo contrario.